Dana 44 Gear Ratio Chart

Dana 44 Gear Ratio Chart – The gear ratio at which carrier breaks occur varies, depending on the type of differential. You have a dana 30 with 3.08 ratio, but. The general rule of thumb for any 4×4 vehicle is for the front and rear ratios to be within 2% of each other (this amount is easily absorbed within the backlashes in the drivetrain) and. 3.07, 3.31, 3.54, 3.73, 4.09, 4.27, and 4.54 for normal use.

For example, if you have a dana 44 axle with a gear ratio. Dana 44 rear ends have two carrier sizes or breaks; 8.5 / 216mm pinion diameter /.

Last Edited By Studerich ;

If you change the ratio to a 4.09, you must change to a high. If there is another gearing. This article about an automotive part or component is a stub.

Dana 44 Has A Maximum Torque Load Rating Of 4,400Lbs.

Differentials designed for 3.73 and numerically lower gears require thick gears for 3.92 and higher ratios. New_gen_dana_44_comparison_chart_dynatrac here’s where it gets. 8.5 / 216mm ring gear diameter:

Note That All Dana 44 Axles Feature A 3.73/3.92 Carrier Break.

The bill of material (bom) number is used to identify dana differentials. The sustained torque rating would actually be much less. Dana 30 3.55 and down, 3.73 and up dana 35 3.08 and down, 3.55 and up dana 44 4.88 and down, 4.89 and up example:

A Pair Of Carrier Sizes Splits These Offerings.

The number can usually be found on the lower right side rib below the differential cover, but it may also be. You can download this chart in pdf form by clicking here: Any gear size from 2.72:1 to 3.73:1 will use one carrier, gears from 3.92:1 up to 5.89:1 use another.

Look For A 44 Or 60 Cast Into The Reinforcement Ribs.

This is referred to as a 3.73/3.92 “carrier break.”. The maximum multiplied lowest gear ratio, to include first gear, transfer case low range, and axle ratio. Dana 44 axles used in '60's studebakers came in: